The RSW Wired, Smart Wind transducer is a professional-level wind sensor designed to deliver highly accurate calibrated wind speed and direction data. Supplied with a 30m Smart Wind mast cable as standard.
Raymarine Smart Wind technology delivers expert level accuracy without the need for additional, expensive processors or extensive calibration and set-up.
Through rigorous wind tunnel testing, we've fine-tuned and balanced the instrument to ensure that data from the mast head is accurate and consistent.
Select your Raymarine RSW Wired below. Additional Smart Wind cabling in either 30m or 50m lengths can be purchased separately.
RSW Wired SKU: E70670
RSW Wired - Smart Performance Wind Transducer, Short Arm with 30m Cable
Wind transducer (including cable): 657.762 mm (25.90 in)
Wind transducer (excluding cable): 540.712 mm (21.29 in)
Wired gateway: 155.61 mm (6.13 in)
Wind transducer: 46.96 mm (1.85 in)
Wired gateway: 47.38 mm (1.88 in)
Wind transducer: 305.86 mm (12.04 in)
Wired gateway: 30.61 mm (1.21 in)
|Nominal supply voltage||
12 V dc (via SeaTalk NG)
|Operating voltage range||
9 V to 16 V dc
< 100 mW
Ensure that the SeaTalk NG backbone is protected by a 5 A fuse
|NMEA 2000 LEN (Load Equivalency Number) - based on nominal 9 V rating:||
|Operating temperature range||
-25°C to +55°C (-13°F to +131°F)
|Storage temperature range||
-30°C to +70°C (-22°F to +158°F)
Below deck: up to 93% @ 40°C
Wind transducer: IPx7
Wired gateway: IPx6
115 mph (185 kph)
EN 60945:2002 (exposed)
|Europe, Australia & New Zealand||
CFR47 Part 15
|Japan / China||
IACS section E10
The following parts are supplied with the RSW-Wired.
No.10 x 3/4" self tapping screws x 4 (for mounting the wind transducer)
No.7 x 3/4" self tapping screws x 2 (for mounting the gateway)
40 mm (1.57 in) heat shrink tube (required to insulate ground wire when shortening the mast cable)
Ring crimp terminal (required for additional ground connection when the gateway is not mounted on a metal surface)
Mast cable, 30 m (98.43 ft) reel
Smart wind wired gateway
SeaTalk NG to DeviceNet adaptor cable, 120 mm (4.72 in)