• Applicable for:  ITC-5
  • Software Version: App v1.12 - Bootcode - v1.14
  • Release Date: August 2014
  • Replaces: v1.04, v1.05
 
  • Important note: This release includes both Application and Bootloader.  Please make sure both are installed.  Once you have installed the Bootloader, you have to re-install the Application code.
    •  See the README included in the download in G Series and a/c/e/gS Series MFD's
     
 

Downloading the Software


Select the software update below depending on which Multifunction Display you will be using to perform the Remote Update. Please note if you have a G Series or a/c/e/gS Series you must check what version of software you have installed in the unit that you are using to perform the upgrade (we require G-Series to be on latest release). For further information on this please click here.


Current MFDs

 

AXIOM/AXIOM Pro

AXIOM 7 184x169DownloadBootcode   

eS Series

eS SeriesDownloadBootcode   

a/c/e/gS Series

a/c/e/gS Series Software | Raymarine by FLIRDownloadBootcode   
 

Retired / Legacy MFDs

 

G Series

G SeriesDownload  

E Wide

E WideDownload  

C Wide

C WideDownload  

E Classic

E ClassicDownload  

C Classic

C ClassicUnavailable  

A Classic

A ClassicDownload  
 
 


 

IMPORTANT TERMS OF DOWNLOADING SOFTWARE

 

This firmware update process is done at your own risk. Before initiating the update process be sure to backup and make copies of all important files

If the firmware process is interrupted your product may not function properly, therefore do not interrupt the process and ensure the unit is on a reliable power supply. Damage caused by incomplete upgrades will not be covered by Raymarine warranty. 

By Downloading the software, you agree to these terms.

 

 


Software History


Version Release Date Features
App v1.12
Bootcode v1.14
August 2014  
Application
  • Accuracy of the Wind Speed calibration of the RotaVector has been improved.
  • The default Wind calibration factor is now correct for use with the current Mast head unit.
  • Resolution of the rudder bar output has been increased to provide a smoother needle movement on an i70 or MFD.
  •  
  • Corrects an issue with the depth function where depth data was output onto the STNG bus when a Depth Transducer was not connected.
  • Allows speed points to be set to SOG when calibrating the Transducer with an i70 using v2.17 (or higher) software.
 

 

Bootloader 

  • Corrects an issue that could intermittently cause the unit to fail to start-up.
  • Corrects an issue that could cause intermittent or no wind data.
 

Note: Downloading software to the ITC-5 will reset the Transducer calibration settings. Once the Bootloader file has been installed, you then have to re-install the Application file.


v1.05 April 2013
  • Linearize Wind from ST70/ST70+
 
v1.04 April 2013
  • Initial Release